Pull-down menu 
New
You annotate standard parts by activating the standard part and identifying the start and end points of the leader line.
The standard designation is then entered automatically.
This function globally pre-sets the representation of the text block, and the setting then applies to all subsequently created text blocks.
This function globally pre-sets the representation of the leader line, and the setting then applies to all subsequently created texts with leader lines.
This function globally pre-sets the representation of the item number, and the setting then applies to all subsequent item numbers.
This function globally pre-sets the representation of the standard designation, and the setting then applies to all subsequent standard designations.
Pull-down menu Leader line
Selecting this function opens the Annotation Editor.
Use these functions to change the font of the annotation. One distinguishes between item numbers and standard designations (texts). If you want to change both, select All. When you call the function, the dialogue for the modification of text parameters will first be displayed. Save your changes with OK, then change the item numbers.
If you have selected the In rectangle option, you now need to draw the rectangle. Otherwise, the fonts in the active Part, or All fonts of the drawing will be changed after the confirmation with OK.
First select the annotation, then select a superordinate part for the new annotation. After this you can draw the leader line. Finally, HiCAD prompts you to specify the insertion point for the annotation.
Use this function to change a series of item numbers. Proceed as follows:
- Enter the item number with which you want to start, e.g. 10.
- Select the last number, e.g. 21.
- Now enter the desired difference for the item numbers, e.g. 3.
All item numbers between 10 and 21 will then be increased by 3.
