The functions always refer to the active 2-D part.Use the functions contained in the Properties function group of the 2-D Part tab to process the attributes of 2-D parts.
The functions always refer to the active 2-D part.
|
Functions |
Description |
|
|---|---|---|
|
|
|
|
Pull-down menu Attr.  |
||
|
Enables you to change the part name by entering a new name. | |
|
|
|
|
|
|
|
|
|
|
|
You use this function to convert parts into construction aids and construction aids to parts. The construction aids are not displayed in the browser. |
|
|
This function assigns a material to the active part. |
|
|
|
If you enter the new scale and a fixed point, the size of the representation changes. The fixed point marks the position of the part after the change of scale. If you change the main scale of the drawing from 1:1 to 1:2, the part scale will be changed proportionally, i.e. a part scale of 1:5 will then change to 1:10. For 2-D parts, the scale in the Properties tab of the ICN is represented as 1:n [1:m]. The scale shown in square brackets is the part scale, the other scale is the result from part scale and main scale of the drawing. If the main scale is, for example, 1:2, and the part scale is 1:3, then 1:1.5 [1:3] will be displayed. If the main scale and the part scale are identical, e.g. 1:2, the part will (in relation to the main scale) be displayed without size change. An example: The displayed drawing was created with a scale of 1:2. Then, the two parts of equal size were drawn. In both cases, a scale of 1:1 [1:2] will be displayed. If you now set the part scale of Part 2 to 1:3, this will cause Part 2 to be displayed smaller in relation to the main scale. A scale of 1:1.5 [1:3] will then be displayed. The scale for Part 1 will remain unchanged. |
Part Functions (2-D) • Save Part (2-D)
|
© Copyright 1994-2018, ISD Software und Systeme GmbH |
(1) Original, (2) After change of the part scale