Drive connections are created to link drive symbol connections to the connections on other symbols.
If the new drive connection is the only connection to a Drive symbol, it is automatically assigned to the symbol to which the connection should be created. This only applies if the symbol is a General type, not another drive symbol, a gauge symbol or a Pipe part type. This assignment causes the dialogue from the data mask of the superior symbol to be copied to the drive symbol as follows:
| Superior Symbol Dialogue Type | Drive Symbol Dialogue Types | |
|---|---|---|
|
For all symbol types |
||
|
Plant code |
==> |
Plant code |
|
Plant unit |
==> |
Plant unit |
|
Aggregate |
==> |
Aggregate |
|
For symbol type "General type" |
||
|
ID acc. to KKS Aggregate |
==> |
Device, superior |
|
ID acc. to DIN code |
==> |
Device, superior |
|
For symbol type "Pipe part" |
||
|
Pipeline number |
==> |
Pipeline No. |
|
Internal consecutive number |
==> |
Internal consecutive No. |
Connection (P+ID) • Pipe Connection, General (P+ID) • Signal Connection, General (P+ID)
|
© Copyright 1994-2018, ISD Software und Systeme GmbH |