> ... Sheet Metal > Sheet development > Update > ...
The Update function and its pull-down menu contains functions for adjusting of sheet developments and the parameter settings. The parameters will only affect the current drawing. The development parameters for new drawings can be specified in the Configuration Editor at Sheet Metal > Sheet development > Default setting.
|
Function |
Description |
|
|---|---|---|
|
|
This function updates all developments of the active sheet. If the developments have different parameters, these will be preserved, since the parameters are saved in the development. If a development has been locked against changes, the changes will not be applied. |
|
|
|
||
|
|
This function updates all developments in the drawing, e.g. after changes to the Sheet Metal part. If the developments have different parameters, these will be preserved, since the parameters are saved in the development. If a development has been locked against changes, the changes will not be applied. |
|
|
|
Use this function to change the parameters after selecting the development. If a development has been locked against changes, an error message will be displayed. |
|
|
|
Use this function to change the parameters of all developments in the drawing. In the dialogue window, activate the checkboxes of the parameters that are to be shown in the development. The parameters will be taken over to the default settings. |
|
|
|
Use this function to specify the development parameters for new developments in the current drawing that you create with the Develop sheet function. In the dialogue window, activate the checkboxes of the parameters that are to be shown in the development. |
|
| Up to HiCAD 2016 | ||
Please note:
If you are working with referenced parts, please remember the following:
The link between 3-D part and 2-D development is made, once the edge to be developed
has been selected, by means of two points placed in layer 0 which lie
on the edge and on the corresponding lines in the blank. If these points
do not exist, the development will be re-generated, rather than updated.
When using referenced parts, you therefore need to bear in mind that an
update can only be performed if the referenced part is saved after the
development is generated and no new development of the part specifying another
edge is generated after this
Overview of Functions (3-D SM) • General Notes on Sheet Metal Processing (3-D SM) • Sheet Development (3-D SM) • Development Parameters (3-D SM) • Update Development (3-D SM)
|
© Copyright 1994-2018, ISD Software und Systeme GmbH |
