Standard Part Designation Tag

3-D Dimensioning + Text > Text > Standard designation

You use this function to assign an annotation to standard parts and standard processings. It uses the current settings for standard part annotations which you define in the context menu for standard part designations - regardless of the settings for other annotations.

1. Identify an edge of the standard part or the standard processing.
2. Define the start point of the leader line.
3. Define the inflexion points and the end point.
4. Right-click to conclude specification of the leader line, and the annotation is created.

 

Please note:

• Standard part designation tags cannot only be used for standard parts and standard processings; they can also be attached to round edges if desired.

• You can specify in the Configuration Editor (ISDConfigEditor.exe) at System settings > Annotation tags > Querying of coincident points how to proceed for the identification of base points that coincide with other points.
• No query
  
  HiCAD identifies the uppermost of the coincident points.
• Query
  
  Here you will be asked to specify the point you want to identify. To do this, enter the corresponding point number. HiCAD numbers the points from front to back, i.e. the point in the front has the highest number. This is the default setting.
  
• Use general setting
  Here the general setting specified at System settings > Identification > Querying of coincident points will be used. If the checkbox has been activated here, HiCAD will display a query, otherwise not.

Part Annotation (3-D) • Change Annotation Settings (3-D) • Texts and Annotations (3-D)