> Define > Pattern contour - Change patterning parameters 
2-D Part > Hatching > Define > Define > Pattern contour - Change patterning parameters
After choosing the symbol, you can change the desired parameters individually.
|
Function |
Description |
|
|---|---|---|
|
|
Layer |
You use this function to set the patterning layer. Default: Layer 1. |
|
|
Symbol angle |
If you enter an angle, the symbol of a patterning will be rotated. |
|
|
Enlargement factor |
If you enter a factor, the symbol will be enlarged or downsized. |
|
|
Border offset |
Here, you set the distance of the pattern to the edge of the part. |
|
|
Symbol spacing |
This function enables you to set the x- and y-spacing between the symbols of a patterning. |
|
|
Colour |
Use this function to specify the colour of the hatching lines. The hatching colour will be saved to the data storage unit. |
Define Contour Hatching (2-D) • Contour Hatching Exclusion (2-D) • Contour Hatching Parameters (2-D) • Hatching (2-D) • Part Hatching (2-D)
|
© Copyright 1994-2018, ISD Software und Systeme GmbH |
