> Define > Change hatching parameters 
2-D Part > Hatching > Define > Define > Change hatching parameters
You use this function to change the parameters of existing contour hatchings. You can specify line type, layer, colour, angle and hatching line spacing separately.
The selected hatching is changed immediately.
|
Function |
Description |
|
|---|---|---|
|
|
Line type |
A selection of line types is available for the hatching lines.
|
|
|
Layer |
You set the layer of the hatching parameters here. The default setting is layer 1. |
|
|
Colour |
This function enables you to set the colour of the hatching lines. The hatching colour is also saved in memory. |
|
|
Hatching angle to axis |
The hatching angle refers to the positive x-axis. You define the default setting by entering the angle. |
|
|
Reference angle |
You can specify the angle of the hatching lines, depending on the position of the part to be hatched. That line which is selected as identification for the contour after the parameters have been changed is taken as the reference line.
|
|
|
Hatching line spacing |
You can define the spacing of the hatching lines. The spacing is specified in mm and is invariant to scale. |
|
|
Edge distance |
You can shorten the hatching lines in the direction of the edge of the part. If the hatching lines are drawn up to the edge of the part, this may give you the optical impression that the hatching lines are protruding over the contour.
|
|
|
Reference line parameters |
This function enables you to apply the attributes of an identified graphical element. |
Define Contour Hatching (2-D) • Change Patterning Parameters (2-D) • Hatching (2-D) • Part Hatching (2-D)
|
© Copyright 1994-2018, ISD Software und Systeme GmbH |
