Calculate System Attributes for BOMs
In HiCAD, new system attributes are available for sheet metal parts and coated surfaces:
|
§SOC |
Calculate surface area from the development contour, internal exclusions and processings are ignored |
|
§S2D |
Calculate rectangular surface area of the development from length * width |
|
§CW |
Calculate weight from the rectangular surface area of the development |
|
§SC |
Calculate the coated surface area for coated sheet metal parts |
In the Configuration Editor, at Modelling > Part properties, you set the system attributes for when the calculation should take place, e.g. for the creation of bills of materials.
The following three procedures are available for selection:
- Do not auto-calculateautomatisch berechnen
- Only for automatic itemization
- Always
Please note:
If the sheet is to be calculated instead of the sheet development, then the setting Development attributes must be selected for the parameter Transfer development dimensions to at Modelling > Part properties.
