Surface Approximation
Drawing > Properties > Attr. 
> Surface approximation 
You use this function to define the number of polygon points for 3-D quadrants. This setting is taken into account, for example, in polyhedral approximation and shading of 3-D models.
- Polygon points per quadrant
Enter the number of polygon points per quadrant (min. 2, max. 100). The default value is 6. If a value of > 10 is selected, this may cause a performance decrease. HiCAD will therefore issue a warning massage. If you want to suppress this warning message, open the Configuration Editor, choose System settings > Miscellaneous, and deactivate the Display error message during polyhedron approximation? checkbox. - Via distance tolerance
Enter a distance tolerance for the polyhedron approximation. The default value is 0.1. - Via distance tolerance with minimum number
Enter a distance tolerance for the polyhedron approximation and the minimum number of polygon points. If a value of > 10 is selected for the polygon points, this may cause a performance decrease. HiCAD will therefore issue a warning massage. - Via distance tolerance with maximum number
Enter a distance tolerance for the polyhedron approximation and the maximum number of polygon points. If a value of > 10 is selected for the polygon points, this may cause a performance decrease. HiCAD will therefore issue a warning massage.
The Via distance tolerance... functions approximate according to a predefined precision value (default = 0.1). The precision value is used to determine the maximum distance permitted between analytical surface and polyhedral surface. The number of polygon points for 3-D quadrants is then calculated separately for each curved surface using this precision value. With minimum number means that the calculated value must not be less that the entered value;with maximum number means that the calculated value should not be greater than the entered value.
|
|
|
|
|
|
Analytical model |
Polygon points |
Polygon points |
Polygon points |
Please note:
- Variable approximation is especially recommended for different fillet radii, which is why the parts should, in principle, be created analytically.
- The setting made here has an effect on the display of shaded models. The higher the value, the cleaner and more exact the shading is. However, it also increases the file size!
- In the Configuration Management under Modeling > Part creation > Polyhedron approximationthe default settings predefined by ISD have been changed as follows:
These settings are well suitable for large drawings.
The settings shown above are also used in the Configuration Templates (CSV files) for mechanical engineering and plant engineering included in the scope of delivery of HiCAD, which are loaded via the Parameter Configuration. The steel/metal configuration template uses 4 division points per quadrant.
