2-D
Drawing
2-D part (Main assembly, Main part or Sub-part)
3-D
Drawing
Part with isolated points
Main assembly
Part with free edges
Assembly
Part with free surfaces
Sketch
Individual Standard Part
Dummy part
Bolting, Standard Part group
Solid
Bolting
3-D Grid
3-D Grid main part
Grid sub-system
Sub-system (sub-part)
Sheet Metal
Flange
Sheet
Bend zone
Steel Engineering
Beam/Profile
Steel Eng. Assembly
Steel Eng. Grid
Steel Eng. Plate
Bolting group
Structure assembly
Metal Engineering
Metal Eng. Planning grid
Glass group
Mullion group
Transom group
Glazing assembly
Insert assembly
Plant Engineering (Standard)
Branch
Pump
Vessel
Reducer, concentric
Blank flange
Reducer, excentr.
Double knee
Elbow
3-way valve
Pipe clamp
Corner valve
Pipeline
Flange
Saddle connection
Flange gasket
T-piece
Straight pipe
2-way valve
Y-pipe
Fastener
Cap
4-way valve
Knee
Other components and pipe parts
Guideline
Elbolet
Gauges
Plant Engineering (Air ducts)
Branch base
Pipe transition
Elbow, symmetrical
Pipe transition, symmetrical
Bend transition
T-piece with
Offset double knee
T-piece without
Offset transition
Transition fitting
Y-piece
Transition, symmetrical
Duct part
Angle, symmetrical
Pipe
Angle transition
Other identifiers
Externally referenced part
Referenced part, no access rights
Internally referenced part
Non-updated referenced part
Error in feature
New/changed, unsaved part
Part with HCM constraints
Assembly main part
Variant
Processing of part not allowed
This symbol is displayed if the processing of a part is not allowed because its article master is has been locked (i.e. the Workflow status does not allow writing). To prevent a processing of a part due to a locked article master, open the Configuration Editor, select System settings > Referencing and activate the checkbox for the parameter Lock parts against processing if HELiOS article master is locked. The checkbox is deactivated by default.
Identifiers for SE with Drawing Management
No database connection exists.
The drawing has not yet been saved to HELiOS, and a product structure does not yet exist.
or
The drawing contains objects that have not yet been saved to HELiOS, and the product structures in HiCAD and HELiOS are not identical.
The product structure of the current drawing is identical in HiCAD and HELiOS.
