Part Type: Seal (PE)

Rules for the creation of individual Plant Engineering parts

Named isolated points

Designation	Purpose	Comment	Position in coordinate system
!	Connecting point	Fitting point	in origin (0,0,0)
2	Connecting point		X = 0, Y = 0, Z > 0

Designation

Purpose

Comment

Position in coordinate system

Connecting point

Fitting point

in origin (0,0,0)

Connecting point

X = 0, Y = 0, Z > 0

Required attributes for entries into database or catalogue

The entering of attribute values and the part type selection should be performed using the PAA Editor.

Values need to be entered for at least the following attributes:

Attribute

Designation

BENENNUNG

Designation of part

NORMBEZEICHNUNG

Standard designation of the part.

An entry is mandatory, even if the part corresponds to no standard.

NENNWEITE

Nominal diameter, Connections “!“ and “2“

DICKE

Seal thickness

Additionally (only if the corresponding standard uses nominal diameters in inches):

NPS_INCH

Nominal diameter (inches) (e.g. 1 1/2‘', the '' consists of two '' characters), Connections “!“ and “2“

ANSCHLUSSART

Connection types for Connections “!“ and “2“ (value = 20000 for flange connection)

Possible values of the attribute ANSCHLUSSART (CONNECTION_TYPE):

2000x

Flange connection

Provide auxiliary part when fitting part

If appropriately preset in the ANSCHLUSSART (CONNECTION_TYPE) attribute for a connection, the part will provide and connect an auxiliary part of the standard specified in the attribute for the connection when being fitted. For example, if the part has a flange connection and the corresponding counter-flange is required, the content of the ANSCHLUSSART (CONNECTION_TYPE) attribute could look as follows:

20002 1 5100010 EN 1092-1/11/A/PN 40

EN 1092-1/11/A/PN 40 is the standard designation with which the flange is to be entered into the database.

2050x

Flange connection of a seal that is exclusively intended for the pushed in end of a push-in pipe. The effect of this value is that a loose flange, together with the push-in pipe, will be connected to the seal. The pushed in of the push-in pipe must have the connection type 10xxx.Flange connection.

The last character (x) provides information about the meaning of the supplement:

0 =No supplement

2 = The supplement consists of connection number, part type, ID, and standard of the part to be connected

The prefixed connection number indicates the connection with which the auxiliary part is to be attached to the current connection.

Please also read the information given in the paragraphs Connection type ID with priority information and Connection type ID - List of part standards.