Project: HiCAD Sheet Metal

Mitre Cut (Standard)

Sheet Metal > Change length > Corner/Mitre > Mode: Mitre

In the Mitre mode you can mitre cut flanges with or without lengthening. The flanges can be located in different Sheet Metal main parts.

  1. On each flange, select an edge of the longitudinal side, or right-click and select the front side.

A preview will be displayed.

  1. Choose a joint.

By choosing the joint you determine either if the inner edge, flush is to be shortened or lengthened or if corners of composite panels are to be closed. For the Groove form you can choose the matching milling tool from the Composite panels, groove form catalogue.

  1. Activate the Lengthen checkbox if you want non-overlapping flanges to be trimmed.
  2. Click OK to apply the preview and close the dialogue window.

If you click Apply, the preview will also be applied, but the window will remain open.

 

With lengthening
(1) First front side
(2) Second front side

Without lengthening

Mitre cut between flanges of different sheets

(1) Composite panels before processing
(2) After procesing: Flanges with milling edges, milling edge zone linear

Corner Processing / Mitre (3-D SM)

© Copyright 1994-2020, ISD Software und Systeme GmbH
Version 2502 - HiCAD Sheet Metal
Date: 24/02/2021     Language: 1033

> Feedback on this topic

Data protection • Terms and Conditions • Cookies • Contact • Legal notes and Disclaimer