Project: HiCAD Sheet Metal

Close Corner, Percental Projection

Sheet Metal > Change length > Corner/Mitre > Mode: Close corner, free > Joint: Projection, percent

Sheet Metal > Change length > Corner/Mitre > Mode: Close corner, closed > Joint: Projection, percent

 

With the mode Close corner, free and the joint type Projection, percent, you can determine the lengthening (or shortening) of a sheet relative to the sheet thickness.

If you choose the mode Close corner, closed and the joint type Projection, percent, the bend zone or milling edge zone will also be lengthened or shortened.

Proceed as follows:

  1. Specify the percentage (0.0 - 1.0 of sheet thickness).
  2. On each flange, select an edge of the longitudinal side, or right-click and select the front side.

The first identified flange will be lengthened, the second flange will be shortened if required.

(1) Percental projection: 0.5 x of the sheet thickness

Close Corner

© Copyright 1994-2020, ISD Software und Systeme GmbH
Version 2502 - HiCAD Sheet Metal
Date: 24/02/2021     Language: 1033

> Feedback on this topic

Data protection • Terms and Conditions • Cookies • Contact • Legal notes and Disclaimer