Project: HiCAD Sheet Metal

Close Corner, With Circular Cutout 

Sheet Metal > Change length > Corner/Mitre > Mode: Close corner, round  

Use this function to closes open corners that are created when adding flanges to a sheet. A round cut-out in the bend zone or milling edge zone will be created in the process. The inner edge can be either specified as Flush or Projection, percent.

Proceed as follows:

  1. On each flange, select an edge of the longitudinal side, or right-click and select the front side.
  2. Specify the diameter of the cut-out.

The corner can be closed then with OK.

(1) Open edge
(2) Front edge
(3) Closed corner, inner edge, flush, with cut-out
(4) Top view of the closed corner

Close Corner

© Copyright 1994-2020, ISD Software und Systeme GmbH
Version 2502 - HiCAD Sheet Metal
Date: 24/02/2021     Language: 1033

> Feedback on this topic

Data protection • Terms and Conditions • Cookies • Contact • Legal notes and Disclaimer