Configuration of BOM-Relevance for Bolting/Riveting Sets

The BOM-relevance in bolting and riveting sets (i.e. the components of a bolting or a riveting) can be configured individually.

For this purpose, a new column called SET is available in the corresponding bolts tables. The BOM-relevance of the individual components is controlled via the string

text\#BR#n1,n2,n3,n4,n5,n6,n7.

text	The text preceding the \ character will be placed at the start of the Article number $BB, e.g. "Garnitur" (German for "Set"). If no text is required, the string can begin with \#BR#
\#BR#	ID for configurable BOM-relevance
	The ID \#BR# is followed by 7 numbers, which determine whether the corresponding part is BOM-relevant or not. The numbers have either the value 0 (not BOM-relevant) or 1 (BOM-relevant).
n1	Bolts
n2	1st washer, top
n3	2nd washer, top
n4	1st washer, bottom
n5	2nd washer, bottom
n6	Nut
n7	Counter nut

If, for example, the bolt and the 1st washer, top are to be BOM-relevant and the text "Garnitur" is to be used, the string must read as follows:

Garnitur\#BR#1,1,0,0,0,0,0

 

Example:

In the Fasteners > Bolts+Screws > Square head bolts catalogue, the SET column for the table DIN 480 has been changed as shown below: 

After saving and closing of the table, these settings will be considered in HiCAD when you insert boltings or rivetings into your drawing.

In the image below, a bolting with the above table has been inserted.

(1) Predefined ISD settings without SET column,

(2) SET column with string Garnitur\#BR#1,0,0,0,0,0,0, i.e. only the bolt is BOM-relevant

(3) SET column with string Garnitur\#BR#1,1,0,0,0,0,0, i.e. the bolt and the 1st washer, top are BOM-relevant