Project: HiCAD P+ID

Move Symbols, In Rectangle

P+ID > Symbol > Move > Move symbol (rectangle), only X or Y

P+ID > Symbol > Move > Move symbol (rectangle), with sketch

P+ID > Symbol > Move > Move symbol (rectangle), without sketch

The following options are available to move several symbols within a specified rectangle:

	In rectangle, only X and Y	This option enables you to move all symbols contained in a given rectangle along the x or y-axis of the sketch grid set for P+ID.
	In rectangle, with sketch	This option enables you to move all symbols contained in a given rectangle in any direction on the sketch grid set for P+ID.
	In rectangle, without sketch	This option enables you to move all symbols contained in a given rectangle without using sketch mode.

First specify two points to create the required box, and then specify the start and end point of the move.

Important:

Normally, connections are always retained after moving the symbols. HiCAD only offers deletion when a moved connection runs diagonally. If symbols are pushed to another joint, they are ignored.

If a connection with a flow-direction arrow is completely contained in a box, the relative position of the arrow on the connection is retained. If only a point of the connection is contained in a box, the flow-direction arrow is moved to the centre of the moved connection.

Transform Symbol (P+ID)

> Feedback on this topic