Project: HiCAD 3-D

Example: Clone Part, Combining Parametric Patterns

3-D Standard > Clone > Param.

The cylinder shown below (Height 80, Diameter 30, centre point of bottom surface in origin) is, in a first step, to be cloned 6 times by a linear displacement in Y-direction - both in positive and negative direction. In the next step these clones are to be cloned again, including the original part, 6 times by rotation about the Z-axis.

The result should look like this:

Proceed as follows:

• Activate the cylinder and choose Param. .
• Choose Add linear pattern .
• Choose the Y-axis as the direction and specify the other settings as shown below:

• Choose Add rotatory pattern and specify the other settings as shown below:

• Click OK.

If you entered an individual distance of 200 for the rotatory pattern, the result would look as follows:

Transform + Clone Part (3-D) • Transform Part (3-D) • Referencing (3-D)