Rules for the creation of individual Plant Engineering parts
Named isolated points
|
Designation |
Purpose |
Comment |
Position in coordinate system |
|---|---|---|---|
|
! |
Connecting point |
Fitting point |
in origin (0,0,0) |
|
2 |
Auxiliary point |
|
X = 0, Y = 0, Z > 0 |
Required attributes for entries into database or catalogue
The entering of attribute values and the part type selection should be performed using the PAA Editor.
Values need to be entered for at least the following attributes:
|
Attribute |
Description |
|||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
BENENNUNG |
Designation of part |
|||||||||||||||||||||
|
NORMBEZEICHNUNG |
Standard designation of the part. An entry is mandatory, even if the part corresponds to no standard. |
|||||||||||||||||||||
|
|
|
|||||||||||||||||||||
|
NENNWEITE |
Nominal diameter, Connection “!“ |
|||||||||||||||||||||
|
|
|
|||||||||||||||||||||
|
Additionally (only if the corresponding standard uses nominal diameters in inches): |
||||||||||||||||||||||
|
NPS_INCH |
Nominal diameter (inches) (e.g. 1 1/2‘', the '' consists of two '' characters), Connection “!“ |
|||||||||||||||||||||
|
|
|
|||||||||||||||||||||
|
ANSCHLUSSART |
Connection type for Connection "!" (always flange connection) |
|||||||||||||||||||||
|
Possible values of the attribute ANSCHLUSSART (CONNECTION_TYPE):
The last character (x) provides information about the meaning of the supplement: 0 =No supplement 2 = The supplement consists of connection number, part type, ID, and standard of the part to be connected The prefixed connection number indicates the connection with which the auxiliary part is to be attached to the current connection.
|
||||||||||||||||||||||
Creating Individual Parts: Procedure (PE)
|
© Copyright 1994-2018, ISD Software und Systeme GmbH |
Please also read the information given in the paragraphs