(1) Start point of the parallel (2) End point of the parallel (3) Contour start (4) Contour end
© Copyright 1994-2018, ISD Software und Systeme GmbH Version 2302 - HiCAD 2-D Date: 14/09/2018
> Feedback on this topic
If you have found a mistake in the Online Help, or have any suggestions concerning the Help, please use this form to directly forward your feedback to our Documentation Team. Enter your name, your E-mail adress and your comment and click Send. Please note however that the Documentation Team does not provide any technical support.
Your name *:
Your E-mail adress *:
Your message *:
* = Mandatory field
Close
