Pipe Parts: T-Pieces (PE)

Plant Engineering > New > Pipe parts > T-piece

In guideline mode, you should draw the vertical branching of a guideline (control edges) before inserting the part – starting on an edge belonging to the other guideline.

The part is then interactively set on the branch point with the help of the named isolated point 4. HiCAD automatically aligns the part in the given direction of the branch.

T-pieces on edge branching

This function is only available in guideline mode. If necessary, the given nominal diameter values for both guidelines (control edges) are used as search criteria.

Set all
This function is only available in guideline mode. In this case all guideline end points in the active pipeline are detected, that are set on another guideline in this pipeline. The appropriate T-Pieces are automatically set on these points.

Part selection and alignment are carried out as for the function T-pieces > On edge branching.